Now fitting the bodywork for the last time. So far the fit has not been too bad, had a little sanding to do around the dash hoop to get the required 400mm gap at the back. It actually lined up initially but went out when I clamped the bottom rear of the body up. You can see why the bodywork manual keeps getting you to re-check this measurment.
Bit of an issue with the roll bar. Having looked at other builders sites it appears the cross piece on mine has been welded too low, this means it fouls the harness fitting. Have emailed Westfield twice about this so far but no response. I suspect they will just suggest I shorten the spacers but I think this will only foul the boot box.
Had a bit of camera trouble today, took loads of pics while fitting the fuel filler and lights but ran out of memory when filming the start and formatted the card. Now only got these pics after the bits are fitted.